- #Saitek pro flight instrument panel plugin for mac how to
- #Saitek pro flight instrument panel plugin for mac drivers
- #Saitek pro flight instrument panel plugin for mac driver
Then, uninstall all Saitek drivers found by Programs and Features in Control Panel.ĭelete the “ DirectOutput” folders and the contents inside.
Unplug all connected Saitek hardware from the system, if any. If “ SPAD” is installed, remove its entry from the exe.xml file (NOT from the backup).īecause SPAD has conflict issues with the new drivers. These two locations are where the fsx.CFG and Preapar3D.cfg stay. Make a backup copy of the current “ exe.xml” under the following directories whichever appropriate.Ĭ:\Users\\AppData\Roaming\Lockheed Martin\Prepar3D v2 I normally rename the backup of the first DirectOutput folder as DirectOutput01, the second as DirectOutput02. ProFlight_FSX_Plugin_7_0_40_9_圆4_Software.exeīackup the two current “ DirectOutput” folders from the following directories to another location on the computer.Ĭ:\Program Files (x86)\Saitek\DirectOutputĭO NOT mix the contents of these two folders even though they have the same folder name. ♦ Note that Windows’ System Restore Point may not be always good enough to recover a system from errors.ĭownload the installers of the two new drivers under “ Plugins” section on Saitek’s Drivers and Software Page here. This will secure the integrity of your system in case unexpected errors are encountered during installation and can prevent further damages. ♦ Although it is not absolutely necessary, you are STRONGLY RECOMMENDED to firstly backup your whole system ( or at least your System Drive) using Windows Image Backup or any third-party software such as Acronis True Image before proceeding with my installation steps below. Then come back to mine if any problem is encountered. You could run the drivers as usual first. ♦ As mentioned above, the installation results vary from system to system. They are good for both Windows 10 and Windows 7 systems, upgrade or fresh install. But I don’t have another Windows 10 computer to verify my guess.Īnyway, followings are the revised installation steps I put together based on the various testings I conducted during the day. One of the causes is very likely due to the difference in Windows operating system.
#Saitek pro flight instrument panel plugin for mac how to
However, the same installation procedure didn’t work on my two other Windows 7 computers ( Home & Professional, 64-bit), on which I was testing the same installation in response to those who reported failure in following my Windows 10 installation steps.Īfter scuffling for nearly a day, I finally managed to trace what had gone wrong and found out how to avoid it. The whole process took me about 45 mins including pre-run preparation and data backup, and post-installation data recovery. On my Windows 10 system, I just needed to click on the two drivers one after the other. To me, both statements are true since I experienced both extremes myself over the last few days. To be more exact, their FIPs wouldn’t start up after the installation, even though all the other Saitek gears work as usual. However, there were others telling me the opposite.
Some friends said to me that the installation of these two drivers was as easy as snapping fingers. Saitek’s new ProFlight drivers, “ ProFlight_FSX_Plugin_7_0_40_9_圆4_Software” and “ Saitek_Pro_Flight_Instrument_Panel_7_0_40_9_圆4_Full_pfw”, however, might need a little tweak.
#Saitek pro flight instrument panel plugin for mac driver
Normally, driver installation should be no more than pointing-and-clicking on the mouse.